Coveralls
PL109
OUTER FABRIC COMPOSITION: 53% PU 47% PA
LINING COMPOSITION: 100% PE
COMPONENTS
Front zipper: 1 double slider zip
Leg pleat zipper: 2 coil zips
Collar fastner: 3 plastic snaps
Front fastners: 4 serviceable fastners, 1 decorative fastner
Pocket fastners: 3 plastic snaps
Cuff bands: 10 mm wide white elastic band
Hood elastic: 10 mm wide white elastic band
Waist elastic: 20 mm wide white elastic band
Waist lining elastic: 10 mm wide white elastic band
Hood adjustment velcro: 25 mm wide velcro strip
STANDARDS
This garment complies with the requirement of REGULATION (EU) 2016/425, EN-ISO 13688:2013 and EN 343:2019 for this PPE.
This PPE corresponds to a pair of coveralls that cover from the neck to the wrists and ankles offering protection against the elements. It consists of a yoke and sleeves in one piece. It fastens down the front from the neckline down to the rise by means of a double slider zipper. The sleeves have windbreaker elastic cuffs. Both front panels have a 45 mm wide storm flap that cover the full length of the zipper and fasten with 5 snaps.
At waist height the interior houses a 20 mm elastic band for a closer fit.
At a height of 30 cm, at the bottom exterior side of each leg, there is a zippered opening with a pleat that goes down to the bottom and fastens by means of a zipper, to facilitate putting the garment on.
The neckline is attached to a roll-away hood that adjusts with an elastic band.
The bottom front has two reach-through pockets with storm flaps that fasten with snaps. Also, the top left front panel includes a patch pocket with flap and the same type of fastening as mentioned. To make it easier to put on, the garment is lined with a satin type lining from the neckline down to approximately knee-length.
Colours | Navy Blue |
---|---|
Sizes | P, M, G, E |
Standards | EN 343:2019, EN ISO 13688:2013, REGULATION (EU) 2016/425 |